How do I set up the barcode reader?

Description:
 
Alveni kiosks can optionally carry scanners or barcode readers.
 
This information applies to the Datalogic Gryphon GFS 41xx readers. and 44xx.
 
Process:
 
The Gryphon scanner is self-installed on Windows and Mac computers when connected to the USB port.
 
The factory is set to read codes only when the scan button is pressed. If it is installed in an Alveni kiosk, the scanner is already configured for code detection and automatic reading. If you need to reconfigure it for code detection and automatic scanning, please follow the procedure indicated below.
 
 
To configure the scanner to read codes automatically with barcode reader GFS41XX, it is necessary to perform the following steps:
 
Step 1: Go to page # 6 of the manual.
Step 2: Scan the code that says (Interface Selection: USB-KBD (GFS4170 model only)
Step 3: Go to page # 11
Step 4: Scan the code that says Operating Mode = Automatic (Object Sense)
Step 5: Once the steps are completed, the scanner will be programmed to read the codes automatically once they are passed in front of it.
 
To configure the scanner to read codes automatically with barcode reader GFS44XX it is necessary to perform the following steps:
 
Step 1: Go to page # 3 of the manual.
Step 2: Scan the code that says (Interface Selection: USB-KBD (GFS4400 model only)
Step 3: Go to page # 10
Step 4: Scan the code that says Operating Mode = Automatic (Object Sense)
Step 5: Once the steps are completed, the scanner will be programmed to read the codes automatically once they are passed in front of it.
Note: If you need to configure the scanner for other detection and / or reading modes, refer to the manual of each model.